Installing a Brick Paver Walkway or Interlocking Brick Machine Suppliers

The usage of Bricks or Pavers to develop a sidewalk or outdoor patio complements a home in a way that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily need a pro.

The key to installing a Brick or Paver Walkway is to very first effectively prepare the location where the bricks/pavers are to be installed. The area needs to be removed at least a foot down, removing all topsoil and clay soil. In addition, string lines need to be strung on each side of the sidewalk. The string lines suggest the finished height of the sidewalk.
As soon as the location has been dug, 3/4" gravel stone need to be laid in and tamped down firmly. Then 2" of sand, or stone dust ought to be spread over the gravel. Once again the sand/stone dust ought to be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline should equate to the thickness of the brick or paver.

Now that you have a stable base, position a 1" pipe or journal board the length of the walkway on either side of the pathway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now put on the level sand/stone dust strips of plastic brick borders. Set up a run on both sides of the ready location. These strips will serve as your sidewalk border and help to preserve the stability and shape of the walkway. You can get these plastic strip borders at a lot of house improvement stores. The strips must be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

As soon as this is done, you can then start to lay the bricks/pavers. There are many patterns you can lay. I particularly like the Herring Bone pattern. The secret to laying the bricks/pavers is to make sure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again help maintain the integrity of the pathway.

Inevitably bricks/pavers will need to be cut or split when building the walkway. Unless you want to buy or rent an expensive wetsaw, I would suggest purchasing a simple brick/paver splitter. It is basically a chisel with a large end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you wish to break the brick. Using a hammer strike the butt end of the chisel strongly. You might require to do this a couple of times. You may also want to turn the brick/paver over and strike the opposite of the brick using the hammer and chisle. Within a couple of strikes the brick/paver ought to break cleanly. , if your pathway has curves you will need to buy/rent a wetsaw.

.

After installing the bricks, build up the outdoors edges with extra sand, and then shovel in the topsoil and load down securely.
Spread stone dust over the new walkway and sweep into the fractures. This will complete the interlocking of the bricks and assist to eliminate any weed development.


In addition, installing a Brick or Paver pathway does not necessarily require a pro. The secret to installing a Brick or Paver Walkway is to very first correctly prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, check here place a 1" pipeline or journal board the length of the pathway on either side of the sidewalk. These strips will act as your walkway border and assistance to maintain the integrity and shape of the sidewalk. Undoubtedly bricks/pavers will need to be cut or divided when building the pathway.

Leave a Reply

Your email address will not be published. Required fields are marked *